1. The vinyl dip is designated as Flexabar Marine or Athletic Vinyl depending on the application. It is available in a wide range of colors including clear.
    
2. Dip the foam parts into the adjusted vinyl solution so that all surfaces are wetted. Hang the parts and allow to drain until dry to the touch (approximately 1/2 hour). The parts then can be re-dipped as often as needed in order to build up the desired film thickness. Each dip treatment will deposit approximately three (3) mils of dried film. The parts should be reversed after each dip so that, upon draining, there is an even distribution of film thickness.
    
3. Flexabar Vinyl can also be applied by brush, roller or spray.

PRODUCTION HANDLING PRECAUTIONS
Flexabar coatings are for industrial use only.

1. Vinyl coating: Since the volatile portion of the finish is flammable solvents, use the following precautions:
   • Keep away from heat, open flame and sparks
   • No smoking or open lights
   • Use with adequate ventilation
   • Avoid breathing of vapor
   • Avoid contact with skin and clothing
   • Close container after use
   • Do not transfer contents to unlabeled containers
   • Do not take internally
   • Keep out of reach of children